More PsyPhin tools psyphin.co.za

South Africa · 4x4 tyre pressure guide

4x4 Tyre Pressures

What tyre pressure to run for the terrain ahead, from what tyre makers publish. A starting point: carry a gauge and a compressor, and adjust from there.

Works offline once you've opened it with signal. Nothing you enter leaves your phone. Page visits are counted anonymously, without cookies.

Load on each axle
kg
kg

Filled in with a typical loaded double-cab bakkie (example figures, not from a source): change them to yours. Best: weigh each axle, loaded for the trip, on a weighbridge. Worst case: the maximum axle loads on the vehicle's VIN or compliance plate. Each tyre carries half its axle.

Your tyres

LT tyres have "LT" before the size (LT265/75R16) or two load numbers, like 121/118. Not sure? You get the passenger-type answer, the more careful one.

As on the sidewall, e.g. 265/60R18, LT265/75R16 or 31x10.50R15. Add the load index if you know it (the number after the size).

Where do I find these on the tyre?
Loaded weight (optional)
kg

With people, fuel, water and gear. A weighbridge is best. The GVM on your licence disc is the most it may weigh. Needs the tyre size above.

Road pressure
bar
bar

From the tyre placard, usually on the driver's door pillar, or in the owner's manual. Use the loaded figure if it gives one. Leave blank to use only the load tables.

Terrain
What you plan to run
bar
bar
km/h
Pumping back up (optional)
%
s

Unscrewing, walking round and connecting the next tyre. Your own estimate: 30 seconds is filled in.

m

Your phone's map or compass app shows it. The coast is 0 m and Gauteng is about 1 500–1 800 m.

Your pressures

Why the numbers work like this

The load tables set the floor

A tyre's load table gives the load it may carry at each pressure. Find the load on one tyre (half the axle), then the lowest pressure that carries it: that's the least the tyre needs. South African law (reg 238) doesn't allow a wheel on a public road, gravel roads included, to carry more than SANS 1550 allows for its tyre, judged at the cold pressure. This page assumes SANS 1550 matches the tables used here, but that hasn't been checked yet.

The tables stop at a lowest pressure: 1.5 bar for passenger-type tyres, 2.4 bar for LT tyres. Below that, nobody publishes what the tyre can carry, so this page shows no floor there. It only shows what tyre makers say about speed.

Contact patch: why airing down helps in sand

A tyre flattens until the pressure over its footprint balances the air pressure inside it. So the footprint is roughly load ÷ pressure: drop the pressure by a third and the footprint grows by about half. It grows mostly in length, which is what floats you over soft sand.

Flex makes heat: why speed has to come down

The lower the pressure, the more the tyre squashes and the more its sidewall flexes on every turn of the wheel. Flexing makes heat, and heat is what destroys tyres. That's why every maker that allows low pressures ties them to low speeds.

Speed and pressure go together

Military trucks with central tyre inflation make the link explicit: each lower pressure setting comes with a lower top speed. These are big truck tyres, so the numbers aren't for your 4x4, but the pattern is the same one BFGoodrich gives for 4x4 tyres: below 1.5 bar, 20 km/h or less.

Beads, rims and side slopes

The tyre's bead sits on the rim's bead seat, held by the flange on the outside and, on a hump rim, a small hump on the inside. ETRTO recommends hump rims for tubeless radial tyres up to load index 121, which covers most 4x4 tyres. At low pressure, a hard sideways push (a side slope, a rut, a sharp turn) can roll the bead over the hump and into the well, and the tyre loses its air. BFGoodrich says to run road pressure across steep side slopes. Beadlocks clamp the bead, but they don't change what the air carries, and Ford doesn't approve them on the road.

Temperature: when to check, and why the reading changes

Set and check pressures cold: with the tyres at the temperature of the air around them, before driving. First thing in the morning is easiest. Otherwise let the vehicle stand (ETRTO says at least an hour, Toyo and Ford say three).

Driving warms the air inside. A reading 20% or more above the cold figure is normal, so never let air out of warm tyres to get back to the cold number. The law also judges a tyre at its cold pressure.

The weather moves it too: about 0.07 bar for every 5.5°C, so a cold desert morning and a hot afternoon can differ by a few tenths of a bar with the same air inside.

Airing down at the start of the sand? The tyres are usually warm by then, so they'll lose a little more as they cool: check again later. The same goes for pumping up warm tyres: they'll read lower once cold.

Keep tyres away from anything hotter than 90°C, such as brakes or exhausts: ETRTO says that can damage them for good.

Corrugations

Corrugations shake the tyre on every ripple, so it flexes more and heats up faster than on smooth gravel. Cooper's advice is to slow down on them. Its slow, rough gravel range (for LT tyres) is what this page uses, and Toyo's 20 per cent rule covers passenger-type tyres. Research on log trucks also found that lower tyre pressures make corrugations form less and improve the ride.

Pumping back up: the physics

The air you need is the tyre's air volume × the pressure you're adding ÷ the air pressure around you. Inland there's less air pressure, so the same tyre needs a little more pumping. Compressors are often rated at "free flow" with nothing to push against. Into a tyre at 2–3 bar they deliver less, so real times are longer.

Common questions

What tyre pressure should I run in sand?

There's no single figure: it depends on your tyre, the load on it and the sand. BFGoodrich says to carry a gauge and let air out 0.5 bar at a time until the tyre floats (0.3 bar at a time on its South African site), and not to go below 1.5 bar (1.4 bar on the South African site). At that pressure, keep under 20 km/h (25 km/h at 1.4 bar).

The calculator above gives a starting range for your tyre and load.

What tyre pressure should I use on gravel roads?

A common starting point from Toyo: going from tar to dirt, drop the pressure by 20% and your speed by 20%. From 2.5 bar that's about 2.0 bar, and from 100 km/h no more than 80 km/h.

Corrugations heat tyres up quickly, so slow down on them.

How fast can I drive on deflated tyres?

Slowly. BFGoodrich: below 1.5 bar, 20 km/h or less. Load, speed and pressure go together: if you lower the pressure and keep the load, you have to slow down, or the tyre flexes more, overheats and can fail later.

Should I let air out when my tyres are hot?

No. Driving warms the air inside, and a reading 20% or more above the cold figure is normal. Never let air out of warm tyres to get back to the cold number.

Set and check pressures cold, before driving: first thing in the morning is easiest.

Do I have to pump my tyres up before the tar?

Yes. Lower pressures are for off-road. When you're back on a paved road, the pressure must go back to the vehicle maker's road figure. Not doing so seriously affects handling and could cause tyre failure, so carry a compressor.